Software Model Number
Model | Description | Software Model Number |
DFUW, DUWC, VUWC | 24 inch Wine Cellar | 11 |
DFUR, DUAR, VUAR | 24 inch Beverage Center | 21 |
DFRD, DURD, VURD | 24 inch Refrigerated Drawers | 16 |
Viking Fridge Diagnostic Information
Service Diagnostics Setting allows you to determine the firmware and software application variations, examination condition of “version particular” system parts as well as sensors, as well as change state of components where suitable (i.e.– compressor on/off, etc.).
Enabling Service Mode: To make it possible for Service Setting, press and hold the “WARMER” switch while pressing the “COLDER” button 4 times within 5 seconds.
- You can not make it possible for Solution Mode while in Set Setting. – All system functions will certainly continue to be in their existing state while in Service Setting.
- Alarms are handicapped during Solution Mode and reset after leaving Solution Setting.
- Service Mode will automatically disable after 5 (5) mins of no keypad entrance
After going into Service Setting, the first number that you will certainly see shows the software version number for the particular system you are servicing. For instance, if you are servicing a 24 inch wine rack (DFUW, DUWC, VUWC), the very first number you will see is 11. See chart below for matching version and also software application recommendation.
The 2nd number you will certainly see indicates the software application version launch. For instance, if you see 44 on the screen panel it indicates software application version 4.4.
Diagnostics:
While in Service Setting, press the “SET” switch to tip through Examinations 0-9. The initial digit of the display will reveal the examination number. The 2nd digit indicates the current state of each part under test and also is displayed as “1” getting on, CLOSED, or SHORTED and also “0” being OFF or OPEN. Tests 0 as well as 1 reveal an open or shorted condition spotted at the sensing unit inputs. Tests 2 with 6 permit you to turn loads ON with the “WARMER” switch and also OFF with the “COLDER” button. Tests 7 via 9 confirm state change of the door switches and/or magnetic reed sensor. The part tests available are defined in Available Part Examinations chart.
SOUND | POSSIBLE CAUSE | SOLUTION |
Humming | Ice maker is in the ‘on’ position without water connection | Stop sound by raising ice maker arm to OFF position see page 3 |